J706 · Seat Occupied Recognition Control Module
- Name
- Seat Occupied Recognition Control Module
- Type
- control module / relay
- Models
- B7 only
- Diagrams
- 2
Location
Its wires run through T17k (In passenger's Seat)inferred from wiring · 14 wires
Other location statements (1)
- Shown in the manual's location figures: Passive Occupant Detection Systemmanual figure p. 1186
Area: Seats
Articles
Pins
One row per pin and wire colour; the pin opens the page of its wire, traced across every sheet. "Connects to" lists the other pins on the same circuit within a diagram; splices and ground points it passes are under "via". The function says how it was worked out: stated by the manual, derived from terminal markings, fuses or the colour code. "Not stated" means the manual only shows what the wire connects.
Pins printed without a connector code likely Sensors
| Pin | Wire | Function | Connects to | Models | Sheets |
|---|---|---|---|---|---|
4 | ge/ws 0.35 mm² | not stated | G453/4 | B7 only | 410 638 |
5 | br 0.35 mm²gror | Ground (terminal 31)stated | E25/2 | B7 only | 410 638 |
6 | br/gn 0.35 mm² | not stated | G452/2 | B7 only | 410 638 |
7 | bl 0.35 mm² | not stated | G452/1 | B7 only | 410 638 |
8 | ge 0.5 mm²ge/grgn/bl | not stated | J234/59 | B7 only | 410 638 |
9 | sw 0.5 mm² | Ignition-switched positive (terminal 15), fused by S11 (5 A)stated | J234/1, K145/2, S11/11avia A139 | B7 only | 410 638 |
14 | ge/ro 0.35 mm² | not stated | G453/5 | B7 only | 410 638 |
15 | gr/ge 0.35 mm² | not stated | G452/3 | B7 only | 410 638 |
16 | br/ws 0.35 mm² | not stated | G453/3 | B7 only | 410 638 |
18 | gn 0.5 mm² | not stated | J234/56 | B7 only | 410 638 |
Diagrams
- 54 · Airbags and Safety Belt Tensioners B7 · From November 2004
- 105 · Airbags and Safety Belt Tensioners B7 · From 2006 m. y.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.