Engines and gearboxes
The engines and gearboxes SSP 254 describes as new for the B6, and the petrol engine and gearbox diagrams in the 12.2005 wiring manual.
SSP 254 does not list the whole B6 engine range. It describes only what was new or changed at launch: two new petrol engines, an upgraded V6 TDI, and changes to the automatic gearboxes. Engines carried over or added later are not described there.
Engines described in SSP 254
Section titled “Engines described in SSP 254”| Engine | Capacity | Power | Torque | Notes from SSP 254 |
|---|---|---|---|---|
| 2.0 l R4 petrol | (see SSP 255) | 96 kW (130 PS) | 195 Nm at 3300 rpm | New design, aluminium housing, EU 4 |
| 3.0 l V6 petrol | 2976 cm³ | 162 kW (220 PS) at 6300 rpm | 300 Nm at 3200 rpm | New design, five-valve heads, aluminium housing, EU 4 |
| 2.5 l V6 TDI | 2496 cm³ | 132 kW (180 PS) | 370 Nm at 1500 rpm | Uprated from the familiar V6 TDI. EU 3 |
SSP 254 credits balancer shafts for the smoothness of the new petrol engines. Full details of the 2.0 and 3.0 are in SSP 255.
2.5 l V6 TDI (132 kW) details
Section titled “2.5 l V6 TDI (132 kW) details”| Item | Value |
|---|---|
| Bore × stroke | 78.3 × 86.4 mm |
| Compression ratio | 18.5 : 1 |
| Injection pump | Bosch VP 44 S3.5 (distributor-type, solenoid-valve controlled) |
| Turbocharger | VNT 20 |
| Emissions class | EU 3 (comfortably below the limits) |
| Consumption (6-speed, quattro) | 11.0 urban / 6.1 extra-urban / 7.8 combined l/100 km |
What changed compared with the earlier 110 kW version:
- Injection pump: pilot injection now works hot and cold, not only during warm-up. To make that possible, the pump got faster solenoid-valve actuation, a cam stroke increased from 3.5 to 4.0 mm, and a stiffer high-pressure section. It also uses two 7.0 mm pistons instead of three 6.0 mm ones, which reduces leakage. Dual-spring nozzle holders reduce noise.
- ICU injectors (“inverse cavity undercut”) with a dual needle guide give better spray formation at small quantities. SSP 254 says this cut exhaust emissions and particulates by up to 20 %.
- Charge-air cooling: the 110 kW engine’s two coolers connected in series could not handle the airflow. The 132 kW engine uses a new layout where part of the charge air bypasses through a duct to the other cooler.
Gearboxes described in SSP 254
Section titled “Gearboxes described in SSP 254”| Gearbox | Used with | What SSP 254 says |
|---|---|---|
| multitronic CVT (01J) | All front-wheel-drive versions | A first in the class for a continuously variable automatic |
| 5-speed automatic 01V with tiptronic | quattro (MY 2001) | New selector gate (below) |
| Manual gearboxes | – | Not described in SSP 254 |
01V selector gate. Positions 4, 3 and 2 are gone and replaced by S, a sport shift programme. SSP 254’s reasons:
- DSP (dynamic shift programme) and tiptronic had made the fixed positions redundant.
- Moving the lever to S at a steady throttle triggers a downshift.
- The torque-converter lock-up clutch is closed wherever possible in S.
- If 5th is an overdrive (4+E ratio), S only uses 1st–4th.
“Tip in D” was new for all automatic gearboxes. Pressing a steering-wheel tip switch while the lever is in D switches to tiptronic mode. The car returns to automatic about 10 s after the last tip. The countdown pauses while cornering or on overrun.
The three-point engine/gearbox mounting is used for every combination except those with the 01V. See Running gear.
Also in the wiring manual
Section titled “Also in the wiring manual”The 12.2005 wiring manual behind the wiring database has diagrams for petrol engines only. It has no diesels and no 2.0 l naturally aspirated engine, so SSP 254’s 2.0 and 2.5 TDI do not appear. The engine diagrams it does contain:
| Engine (as titled in the manual) | Codes | Gen | Diagrams |
|---|---|---|---|
| 1.8 l turbo, 125 kW, 4-cyl | AMB | B6 | 304 (MY 2002), 10 (MY 2003) |
| 3.0 l V6, 162 kW | AVK, BGN | B6 | 303 (MY 2002, AVK), 9 (MY 2003) |
| 4.2 l V8, 253 kW (S4) | BHF | B6 | 12 (MY 2003) |
| 2.0 l TFSI, 147 kW, 4-cyl | BGB, BPG | B7 | 78 (from 11/2004) |
| 3.2 l FSI V6, 188 kW | AUK, BKH | B7 | 95 (from 12/2004) |
| 4.2 l V8, 253 kW (S4) | BBK, BHF | B7 | 89 (from 01/2005) |
| 4.2 l FSI V8, 309 kW (RS4) | BNS | B7 | 102 (MY 2006), 128 (MY 2007) |
And the gearbox diagrams:
| Gearbox | B6 diagrams | B7 diagrams |
|---|---|---|
| multitronic 01J | 320 (MY 2002), 25 (MY 2004) | 87 |
| 5-speed automatic with tiptronic | 26 (MY 2002) | – |
| 6-speed automatic 09L with tiptronic | 43 (from 07/2003), 7 (MY 2004) | 86 |
| Manual (starter / clutch-pedal switch relay) | 42 | 85 |
Radiator-fan diagrams are separate: 15 and 13 for the B6, and 82, 90 and 103 for the B7.
Sources
- SSP 254 – Audi A4 '01 Technical Features — Audi AGPages 18–24. The 2.0 and 3.0 engines are detailed in SSP 255.
- Audi A4 Wiring Diagrams and Component Locations (12.2005), via the wiring databaseEngine and gearbox diagram titles and engine facets.