Wire between G452 and J706
Net n08fcb41b · joined across diagrams
- Function
- G452 Seat Occupied Recognition Pressure Sensor — line to J706 Seat Occupied Recognition Control Module 15endpoints onlyBasis: named after the two parts it connects
- Wire
gr/ge- Models
- B7 only
- Drawn in
- 2 diagrams, 2 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 join between diagrams
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
J706pin15Seat Occupied Recognition Control Module
Parts (1)
G452pin3Seat Occupied Recognition Pressure Sensor
Where these parts are
| Part | Location |
|---|---|
G452 | Shown in the manual's location figures: Passive Occupant Detection Systemmanual figure p. 1186 |
J706 | Its wires run through T17k (In passenger's Seat)inferred from wiring |
Drawing
Wires are gr/ge (grey/yellow) unless a colour is written on them. 2 parts and points, 1 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
54 · Airbags and Safety Belt Tensioners B7 · 1 stretch
Diagram 54 page · joined to other diagrams at G452/3
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.