Skip to content

Search is only available in production builds. Try building and previewing the site to test it out locally.

Radio and amplifier pinouts

Pin by pin: the connectors behind the head unit and on the three factory amplifiers, each checked against the factory wiring manual.

Applies to: B6 and B7VerifiedFrom the factory manual or Audi training material.

This page lists the pins behind the head unit and on the amplifier in the luggage compartment. Each table was checked against the factory wiring manual. The Manual column says whether the manual agrees, and the R (radio) and R12 (amplifier) pages show every wire with its colour and the sheet it is drawn on.

For how to use these when fitting an aftermarket radio, see Installing an aftermarket head unit. For the speaker layout, see OEM sound system.

Head unit: Concert II (B6) and other ISO-type head units

Section titled “Head unit: Concert II (B6) and other ISO-type head units”

The B6 radios (Chorus, Concert, Symphony) and the navigation units of that time use the car harness connectors below. The connector is part of the car, so the layout holds for any factory head unit that plugs into it. Depending on equipment, the red connector D may be missing.

Concert II connector layout: D (10-pin, red) on the left, C (20-pin, black) at the top, B (8-pin, brown) and A (8-pin, black) stacked on the right

Pin Function Manual
1 Bose coding: to ground when a Bose amplifier is fitted not extracted
2 Anti-theft warning system ground not extracted
3 L-line (diagnosis) not extracted
7 Terminal 30, permanent 12 V ro/bl, fused by S239 (20 A), shared with the amplifier feed
8 Terminal 31, ground not extracted

There is no ignition (terminal 15) pin. The radio learns the ignition state over the infotainment CAN bus (connector C pins 7 and 12).

Front speakers on cars without Bose. With Bose, the front speakers hang on the amplifier instead.

Pin Function
3 Right front speaker +
4 Right front speaker −
5 Left front speaker +
6 Left front speaker −

Connector C: external control (20-pin, black; T20d in the manual)

Section titled “Connector C: external control (20-pin, black; T20d in the manual)”

The manual calls this connector T20d, “20-pin connector, black, radio connector I”. Every pin below agrees with the manual.

Pin Function Manual: wire and other end
1 Left rear line signal to amplifier gn 0.35, to R12
2 Right rear line signal to amplifier ws/ge 0.35, to R12
3 Line signal ground br 0.35, audio ground point 610 and R12
4 Left front line signal to amplifier (Bose only) gr 0.35, to the Bose R12
5 Right front line signal to amplifier (Bose only) ge 0.35, to the Bose R12
6 Switched positive to amplifier (“radio on”) ws 0.5, to R12
7 Infotainment CAN High or/li, to the instrument cluster J285 pin 20
10 CD changer ground / shield br/sw, to the CD changer R41
12 Infotainment CAN Low or/br, to J285 pin 19
13 CD changer data in to R41
14 CD changer data out —
15 CD changer clock —
16 Permanent positive to CD changer —
17 Switched positive to CD changer —
18 CD changer ground —
19 Left audio from CD changer —
20 Right audio from CD changer —

Connector D: telephone and navigation (10-pin, red; T10l in the manual)

Section titled “Connector D: telephone and navigation (10-pin, red; T10l in the manual)”
Pin Function Manual
1 Audio mute from the telephone gr, “quiet switch”
3 Audio + from the telephone gn
4 Audio − from the telephone sw
5 Audio + from the navigation system —
6 Audio − from the navigation system —
7 Navigation control wire gr, to the navigation unit J401

The B7’s RNS-E uses a single Quadlock-style housing. This table is from the owner’s sheet. The manual draws the B7 radio with connectors T12m, T12n and T16j, so the numbering is the manual’s own and does not map one to one onto these blocks. Treat this table as unchecked.

RNS-E connector: block A (16 pins) with fuse, blocks B and C (12 pins each)

Block A pin Function Block B pin Function Block C pin Function
2 Right front speaker + 2 CD changer ground 1 Microphone in −
3 Left front speaker + 3 V-signal (speed) 2 Reverse gear signal
6 Right front speaker − 4 CD changer 12 V permanent 3 Line out, front left
7 Left front speaker − 5 K-line 4 Microphone out −
9 Infotainment CAN High 6 Data out to CD changer 5 Line out, rear left
10 Infotainment CAN Low 7 Bose coding to ground 6 Telephone audio in −
11 Telephone mute 8 Left audio from CD changer 7 Microphone in +
12 Ground (terminal 31) 9 Right audio from CD changer 8 Line out ground
13 Switched 12 V (“radio on”) 10 CD changer switched 12 V 9 Line out, front right
14 Anti-theft ground 11 Data in from CD changer 10 Microphone out +
15 Terminal 30, permanent 12 V 12 Clock from CD changer 11 Line out, rear right
16 — 12 Telephone audio in +

In the manual (B7 diagrams 119 and 127), infotainment CAN High and Low are on T16j pins 9 and 10 (or/li, or/br), radio power on T16j 15 and 16 (ro/bl, terminal 30 via S239), and ground on T16j 12 (br 1.5 mm²).

All three factory amplifiers are drawn as R12, Amplifier, in the luggage compartment on the right behind the side trim. The manual draws two variants in every radio diagram, on separate sheets: the standard amplifier (“Amplified Speaker rear”) and the Bose amplifier (“Bose Speaker front/rear”). Which speakers each one drives is in OEM sound system. The B6 sheets carry the notes “up to October 2003” and “from November 2003”, and the Bose pin layout changes between the two.

Variant Connector Manual sheets
Standard 23 pins used (numbered to 23) 333 (B6 2004), 1033 (B6 2002), 762 (B7)
Bose, B6 up to October 2003 25-pin 1034–1035 (B6 2002 MY)
Bose, B6 from November 2003, and B7 32-pin 334–335 (B6 2004), 763–764 (B7), 789–790 (B7 2007)

Standard amplifier connector, pins 1–22/3–23

Pin Function Manual
1 Right rear line input (from radio C2) agrees
2 Line input ground (from radio C3) agrees
3 Left rear line input (from radio C1) agrees
9 Switched positive from radio (C6) agrees
14 Bass speaker + (R100) agrees, ro/gr
15 Bass speaker − agrees, br/gr
17 Left rear speaker + (R15) agrees, br/ge
18 Left rear speaker − agrees, ro/ge
20 Right rear speaker + (R17) agrees, br/ge
21 Right rear speaker − agrees, ro/ge
22 Terminal 31, ground agrees, br 2.5 mm², via splice 346 to the audio ground point 610
23 Terminal 30, permanent 12 V agrees, ro/bl 2.5 mm², fuse S239

Bose amplifier, 25-pin (B6 up to October 2003)

Section titled “Bose amplifier, 25-pin (B6 up to October 2003)”

Bose amplifier 25-pin connector

Pin Function Manual (diagram 323)
1 Centre speaker + (R70) agrees, gn
2 Centre speaker − agrees, sw
6 Line input ground agrees
7 Right rear line input agrees
8 Left rear line input agrees
9 Right front line input agrees
10 Left front line input agrees
11 Terminal 31, ground agrees, br 2.5 mm²
13 Terminal 30, permanent 12 V agrees, ro/bl 2.5 mm²
14 Bass speaker + agrees
15 Bass speaker − agrees
16 Left front speaker − (R21) agrees
17 Left front speaker + agrees
18 Right front speaker + (R23) agrees
19 Right front speaker − agrees
20 Left rear speaker + agrees
21 Left rear speaker − agrees
22 Right rear speaker + agrees
23 Right rear speaker − agrees
25 Switched positive from radio agrees

Bose amplifier, 32-pin (B6 from November 2003, B7)

Section titled “Bose amplifier, 32-pin (B6 from November 2003, B7)”

Bose amplifier 32-pin connector

Pin Function Manual (diagrams 36, 120, 127)
1 Terminal 30, permanent 12 V agrees, ro/bl 4.0 mm²
2 Terminal 31, ground agrees, br 4.0 mm²
3 Bass speaker + agrees, ro/gr 2.5 mm²
4 Left rear speaker − agrees, ro/ge
5 Right rear speaker + agrees, br/ge
6 Switched positive from radio agrees, ws
7 Line input ground agrees, br
13 Centre speaker manual: − (sw); owner’s sheet: +
14 Centre speaker manual: + (gn); owner’s sheet: −
15 Bass speaker − agrees, br/gr 2.5 mm²
16 Left rear speaker + agrees, br/ge
17 Right rear speaker − agrees, ro/gn
19 Left front line input agrees, gr, from radio C4
20 Right front line input agrees, ge, from radio C5
21 Left rear line input agrees, gn, from radio C1
22 Right rear line input agrees, ws, from radio C2
24 — (sheet: unused) manual: ws to the switched-positive splice (B6) or bl/ro to the radio (B7 2007)
26 Right front speaker − agrees, gn/bl
27 Right front speaker + agrees, br/bl
29 Microphone + (sheet: not connected) manual: to the inside microphone R74
30 Microphone − (sheet: not connected) manual: to the inside microphone R74
31 Left front speaker + agrees, br/gn
32 Left front speaker − agrees, bl/ge

Parts in the wiring data

CodeNameModelsLocation
RRadioB6 and B7Top of the center console
R12AmplifierB6 and B7In luggage compartment right, behind side trim
R70Inside loudspeaker (Center Speaker)B6 and B7In dash panel, behind defroster vent
R100Bass LoudspeakerB6 and B7In luggage compartment right, behind side trim
R15Left Rear Bass SpeakerB6 and B7Behind door trim
R17Right Rear Bass SpeakerB6 and B7Behind door trim
R21Left Front Bass SpeakerB6 and B7Behind door trim
R23Right Front Bass SpeakerB6 and B7Behind door trim
R34Left Rear Midrange SpeakerB6 and B7In door trim
R35Right Rear Midrange SpeakerB6 and B7In door trim
R41CD ChangerB6 and B7In glove box
R74Inside MicrophoneB6 and B7In interior light operating unit
S239Fuse in fuse holderB6 and B7Fuse panel at the left end of the instrument panel, fuse No. 39

Sources