Skip to content

Search is only available in production builds. Try building and previewing the site to test it out locally.

Sensor ground

Net ne3eac606 · one diagram

Function
Sensor groundstated
Basis: ground connection 220
Wire
br/sw
Models
B7 only · 2.0 TFSI
Drawn in
1 diagram, 7 stretches
Checked
Not checked by hand. Extracted from the manual automatically.

1 guessed component

What is on this wire

Parts (7)

  • G40pin 3Camshaft Position (CMP) Sensor
  • G42pin 2Intake Air Temperature (IAT) Sensor
  • G62pin 1Engine Coolant Temperature (ECT) Sensor
  • G247pin 1Fuel Pressure Sensor
  • G410pin 1Low Fuel Pressure Sensor
  • J623pin T60/14Engine Control Module (ECM)
  • V157pin 3guessIntake Flap Motor

Grounds (1)

  • 220Ground connection (sensor Ground), in engine wiring harness (ground connection in the harness)

Inline connectors (2)

  • T10zpin 110-Pin Connector, black, in engine compartment
  • T10zpin 910-Pin Connector, black, in engine compartment

Where these parts are

PartLocation
G40Its wires run through T10z (In engine compartment)inferred from wiring
G42Part of Mass Air Flow (MAF) Sensor -G70-manual text p. 1213
G62On coolant line behind cylinder head bank 1manual text p. 1215
G247Its wires run through T14a (In engine compartment, left)inferred from wiring
G410On the right cylinder headmanual text p. 1224
J623Under the plenum chamber covermanual text p. 1204
V157Shown in the manual's location figures: 2.0L BPG and BWTmanual figure p. 1204 p. 1207
220Splice inside the engine wiring harnesssheet legend
T10zIn engine compartmentsheet legend

Drawing

Wires are br/sw (brown/black) unless a colour is written on them. 10 parts and points, 9 connections.

A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.

Stretch by stretch

Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.

  • guess: the component label is not right at the symbol; the part was assigned by position.
78 · 2.0 l - TFSI - Injection Engine (147 kW - Motronic - 4 Cylinder), engine codes BGB, BPG B7 · 7 stretches

Diagram 78 page

Page 523manual · Engine Control Module (ECM), Barometric Pressure (BARO) Sensor, Intake Air Temperature (IAT) Sensor, Engine Coolant Temperature (ECT) Sensor, Intake Manifold Runner Position

TrackWireFromToNotes
85br/sw 0.35 mm²G62 1splice 220
87br/sw 0.5 mm²G42 2splice 220
91br/sw 0.35 mm²V157 3guesssplice 220
95br/sw 0.35 mm²G410 1splice 220
97br/sw 0.35 mm²J623 T60/14splice 220

Page 524manual · Engine Control Module (ECM), Charge Air Pressure Sensor, Camshaft Position (CMP) Sensor, Manifold Absolute Pressure (MAP) Sensor, Fuel Pressure Sensor

TrackWireFromToNotes
99br/sw 0.35 mm²G247 1splice 220
via T10z/1
108br/sw 0.35 mm²G40 3splice 220
via T10z/9

From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.