J496 Auxiliary Engine Coolant Pump Relay: relay switched output (87) to V51 After-Run Coolant Pump
Net n8294c2b3 · one diagram
- Function
- J496 Auxiliary Engine Coolant Pump Relay: relay switched output (87) to V51 After-Run Coolant PumpderivedBasis: relay terminal 87 printed at J496
- Wire
ro/gn- Models
- B7 only · 3.2 FSI
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
J496pin5/87Auxiliary Engine Coolant (EC) Pump Relay
Parts (1)
V51pin1After-Run Coolant Pump
Where these parts are
| Part | Location |
|---|---|
J496 | Relay carrier E-Box, engine codes BKH from 2006 MY, position 1.1 (blue socket) — In electronics box (E-box), plenum chambermanual text p. 1110 |
V51 | In the front left of engine compartment, behind front wheel housing linermanual text p. 1266 |
Drawing
Wires are ro/gn (red/green) unless a colour is written on them. 2 parts and points, 1 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.