Wire between F224 and J810
Net n5d19d83c · one diagram
- Function
- F224 Driver's Lumbar Support Pressure Switch — line to J810 Front Passenger's Power Seat Control Module T32j/30endpoints onlyBasis: named after the two parts it connects
- Wire
or/ge- Models
- B7 only
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 guessed component
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
J810pinT32j/30Front Passenger's Power Seat Control Module
Parts (1)
F224pin1guessDriver's Lumbar Support Pressure Switch
Where these parts are
| Part | Location |
|---|---|
F224 | In or under the driver's seatinferred from name |
J810 | In or under the front passenger's seatinferred from name |
Drawing
Wires are or/ge (orange/yellow) unless a colour is written on them. 2 parts and points, 1 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
- guess: the component label is not right at the symbol; the part was assigned by position.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.