Relay output, normally closed (terminal 87a)
Net n0e102a07 · one diagram
- Function
- Relay output, normally closed (terminal 87a)statedBasis: splice E7 is named so in the legend
- Wire
ro/gn- Models
- B6 only · 4.2 S4
- Drawn in
- 1 diagram, 6 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
S282pin2Engine Electronics Fuse
Parts (3)
Splices (1)
E7Plus connection (87a), in Motronic Multiport Fuel Injection (MFI) wiring harness
Where these parts are
| Part | Location |
|---|---|
J151 | Relay carrier E-Box, engine codes BHF from 2006 MY, position 1.1 (blue socket) — In electronics box (E-box), plenum chambermanual text p. 1109 |
N205 | Wired into the engine compartment wiring harnessinferred from wiring |
N208 | Wired into the engine compartment wiring harnessinferred from wiring |
S282 | Relay carrier E-Box, engine codes BPG, BWT from 2006 MY, position A (blue socket) — In electronics box (E-box), plenum chambermanual text p. 1108 |
E7 | not stated |
Drawing
Wires are ro/gn (red/green) unless a colour is written on them. 5 parts and points, 4 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet. "→ track" is a reference box: the wire continues on that track, at the stretch its page link points to.
12 · 4.2 l - Injection Engine (253 kW - Motronic - 8 Cylinder) engine code BHF B6 · 6 stretches
Page 136manual · Motronic Engine Control Module (ECM), Motronic Engine Control Module (ECM) Power Supply Relay, Fuses
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 35 | ro/gn 1.5 mm² | S282 2 | → track 84 (p. 139) |
Page 139manual · Motronic Engine Control Module (ECM), Valves for camshaft adjustment, After-Run Coolant Pump, Mass Air Flow (MAF) Sensor, Evaporative Emission (EVAP) Canister Purge
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 79 | ro/gn 1.0 mm² | J151 3 | splice E7 | marked * |
| 80 | ro/gn 0.5 mm² | J151 1 | splice E7 | marked * |
| 82 | ro/gn 0.5 mm² | N205 1 | splice E7 | |
| 84 | ro/gn 0.5 mm² | N208 1 | splice E7 | |
| 84 | ro/gn 1.5 mm² | splice E7 | → track 35 (p. 136) |
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.