J220 Motronic Engine Control Module: relay switched output (87) to G40 Camshaft Position Sensor
Net n9bd4f179-141.19 · one diagram
- Function
- J220 Motronic Engine Control Module: relay switched output (87) to G40 Camshaft Position SensorderivedBasis: relay terminal 87 printed at J220
- Wire
bl/li- Models
- B6 only · 4.2 S4
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
J220pin87Motronic Engine Control Module (ECM)
Parts (1)
G40pin2/SCamshaft Position (CMP) Sensor
Where these parts are
| Part | Location |
|---|---|
G40 | Its wires run through T10z (In engine compartment)inferred from wiring |
J220 | In electronics box, plenum chambermanual text p. 1122 |
Drawing
Wires are bl/li (blue/lilac) unless a colour is written on them. 2 parts and points, 1 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.