Wire between G185 and J220 (+1)
Net n8f3f227c · one diagram
- Function
- G185 Sender -2- for accelerator pedal position — line to J220 Motronic Engine Control Module 33endpoints onlyBasis: named after the two parts it connects
- Wire
gr/ge- Models
- B6 only · 4.2 S4
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 guessed component
What is on this wire
Parts (2)
Inline connectors (1)
T17epin517-Pin Connector, white, connector station E-box, plenum chamber
Where these parts are
| Part | Location |
|---|---|
G185 | In accelerator pedal modulemanual text p. 1226 |
J220 | In electronics box, plenum chambermanual text p. 1122 |
T17e | In electronics box, plenum chambermanual text p. 1101 p. 1102 |
Drawing
Wires are gr/ge (grey/yellow) unless a colour is written on them. 3 parts and points, 2 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
- guess: the component label is not right at the symbol; the part was assigned by position.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.