Wire between J344 and J431 (+1)
Net n65038aeb · one diagram
- Function
- J344 Control Module for High intensity gas discharge lamp ↔ J431 15endpoints onlyBasis: named after the two parts it connects
- Wire
gr/ge- Models
- B7 only
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
J431pin15Headlight Range Control Module
Parts (1)
J344pin1Control Module for High intensity gas discharge lamp
Inline connectors (1)
T17cpin817-Pin Connector, red, connector station A-pillar, right
Where these parts are
| Part | Location |
|---|---|
J344 | Wired into the right headlamp wiring harnessinferred from wiring |
J431 | Behind glove boxmanual text p. 1124 |
T17c | On lower right A-pillar, behind trimmanual text p. 1099 |
Drawing
Wires are gr/ge (grey/yellow) unless a colour is written on them. 3 parts and points, 2 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.