J623 Engine Control Module: relay coil (86) to G163 Camshaft Position Sensor 2
Net n3aa53a7b · one diagram
- Function
- J623 Engine Control Module: relay coil (86) to G163 Camshaft Position Sensor 2derivedBasis: relay terminal 86 printed at J623
- Wire
gn/li- Models
- B7 only · 4.2 S4
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
What is on this wire
Parts (2)
Where these parts are
| Part | Location |
|---|---|
G163 | Shown in the manual's location figures: Engine; 3.0L AVK and BGN; 3.2L BKH; 4.2L BHFmanual figure p. 1192 p. 1213 p. 1218 |
J623 | Under the plenum chamber covermanual text p. 1204 |
Drawing
Wires are gn/li (green/lilac) unless a colour is written on them. 2 parts and points, 1 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.