Fused supply, after fuse 234, fused by S232 (20 A)
Net n27b3507b · joined across diagrams
- Function
- Fused supply, after fuse 234, fused by S232 (20 A)statedBasis: splice D22 is named so in the legend
- Also named
- Relay output (terminal 87) · Fused supply, after fuse 234
- Wire
gn/gews- Models
- B6 only · 3.0 V6
- Drawn in
- 2 diagrams, 38 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 join between diagrams4 guessed components
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
S232pin234aFuse in fuse holder
Parts (6)
Splices (2)
Inline connectors (5)
T4apin14-Pin Connector, green, connector station Heated Oxygen Sensor (HO2S) (firewall)T4cpin14-Pin Connector, brown, connector station Heated Oxygen Sensor (HO2S) (firewall)T6pin36-Pin Connector, black, connector station Heated Oxygen Sensor (HO2S) (firewall)T6apin36-Pin Connector, black, connector station Heated Oxygen Sensor (HO2S) (firewall)T10apin810-Pin Connector, brown, connector station E-box, plenum chamber
Where these parts are
| Part | Location |
|---|---|
G70 | Wired into the engine compartment wiring harnessinferred from wiring |
J299 | Relay carrier E-Box, engine codes BHF from 2006 MY, position 3 (black socket) — In electronics box (E-box), plenum chambermanual text p. 1109 |
N80 | Wired into the engine compartment wiring harnessinferred from wiring |
N112 | Below intake manifoldmanual text p. 1194 |
N156 | Shown in the manual's location figures: Engine; 3.0L AVK and BGN; 4.2L BHFmanual figure p. 1192 p. 1216 p. 1222 |
S232 | Fuse panel at the left end of the instrument panel, fuse No. 32manual text p. 1115 p. 1119 |
V144 | In the left rear wheel housing behind wheel housing linermanual text p. 1200 p. 1224 p. 1235 |
A152 | Splice inside the instrument panel wiring harnesssheet legend |
D22 | Splice inside the wiring harnesssheet legend |
T4a | Connector station Heated Oxygen Sensor (HO2S) (firewall)sheet legend |
T4c | Connector station Heated Oxygen Sensor (HO2S) (firewall)sheet legend |
T6 | Connector station Heated Oxygen Sensor (HO2S) (firewall)sheet legend |
T6a | Connector station Heated Oxygen Sensor (HO2S) (firewall)sheet legend |
T10a | Connector station E-box, plenum chambersheet legend |
Drawing
Wires are gn/ge (green/yellow) unless a colour is written on them. 29 parts and points, 34 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet. "→ track" is a reference box: the wire continues on that track, at the stretch its page link points to.
- guess: the component label is not right at the symbol; the part was assigned by position.
9 · 3.0 l - Injection Engine (162 kW - Motronic - 6 Cylinder) engine code AVK, BGN B6 · 19 stretches
Diagram 9 page · joined to other diagrams at S232/234a
Page 99manual · Ignition/Starter Switch, Fuel Pump (FP) Relay, Fuses
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 27 | gn/ge 1.5 mm² | splice A152 | → track 57 (p. 102) | |
| 27 | gn/ge 1.5 mm² | S232 234a | splice A152 | |
| 28 | gn/ge 0.5 mm² | splice A152 | → track 45 (p. 101) |
Page 101manual · Motronic Engine Control Module, Fuel Injectors, Leak detection pump (LDP)
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 45 | gn/ge 0.5 mm² | V144 3 | → track 28 (p. 99) |
Page 102manual · Motronic Engine Control Module, Mass Air Flow (MAF) Sensor, Evaporative Emission (EVAP) Canister Purge Regulator Valve, Secondary Air Injection (AIR) Solenoid
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 57 | gn/ge 1.5 mm² | → track 27 (p. 99) | splice D22 | via T10a/8 |
| 57 | gn/ge 0.5 mm² | splice D22 | → track 151 (p. 108) | |
| 59 | gn/ge 1.0 mm² | N80 1 | splice D22 | |
| 61 | gn/ge 0.5 mm² | N156 1 | splice D22 | |
| 61 | gn/ge 0.5 mm² | splice D22 | → track 118 (p. 106) | |
| 63 | gn/ge 0.5 mm² | N112 1 | splice D22 | |
| 63 | gn/ge 1.0 mm² | splice D22 | → track 125 (p. 106) | |
| 65 | gn/ge 0.5 mm² | splice D22 | → track 132 (p. 107) | |
| 67 | gn/ge 0.5 mm² | G70 2 | splice D22 | |
| 67 | gn/ge 1.0 mm² | splice D22 | → track 139 (p. 107) |
Page 106manual · Motronic Engine Control Module, Heated Oxygen Sensors
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 118 | gn/ge → ws 0.5 mm² | → track 61 (p. 102) | joint | via T4a/1 |
| 125 | gn/ge → ws 1.0 mm² | → track 63 (p. 102) | joint | via T6/3 |
303 · 3.0 l - Injection Engine (162 kW - Motronic - 6 Cylinder) engine code AVK B6 · 19 stretches
Diagram 303 page · joined to other diagrams at S232/234a
Page 866manual · Ignition/Starter Switch, Fuel Pump (FP) Relay, Fuses
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 27 | gn/ge 1.5 mm² | splice A152 | → track 57 (p. 869) | |
| 27 | gn/ge 1.5 mm² | S232 234a | splice A152 | |
| 28 | gn/ge 0.5 mm² | splice A152 | → track 45 (p. 868) |
Page 868manual · Motronic Engine Control Module, Fuel Injectors, Leak detection pump (LDP)
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 45 | gn/ge 0.5 mm² | V144 3 | → track 28 (p. 866) |
Page 869manual · Motronic Engine Control Module, Mass Air Flow (MAF) Sensor, Evaporative Emission (EVAP) Canister Purge Regulator Valve, Secondary Air Injection (AIR) Solenoid
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 57 | gn/ge 1.5 mm² | → track 27 (p. 866) | splice D22 | via T10a/8 |
| 57 | gn/ge 0.5 mm² | splice D22 | → track 151 (p. 875) | |
| 59 | gn/ge 1.0 mm² | N80 1 | splice D22 | |
| 61 | gn/ge 0.5 mm² | N156 1guess | splice D22 | |
| 61 | gn/ge 0.5 mm² | splice D22 | → track 118 (p. 873) | |
| 63 | gn/ge 0.5 mm² | N112 1guess | splice D22 | |
| 63 | gn/ge 1.0 mm² | splice D22 | → track 125 (p. 873) | |
| 65 | gn/ge 0.5 mm² | splice D22 | → track 132 (p. 874) | |
| 67 | gn/ge 0.5 mm² | G70 2 | splice D22 | |
| 67 | gn/ge 1.0 mm² | splice D22 | → track 139 (p. 874) |
Page 873manual · Motronic Engine Control Module, Heated Oxygen Sensors
| Track | Wire | From | To | Notes |
|---|---|---|---|---|
| 118 | gn/ge → ws 0.5 mm² | → track 61 (p. 869) | joint | via T4a/1 |
| 125 | gn/ge → ws 1.0 mm² | → track 63 (p. 869) | joint | via T6/3 |
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.