Wire between G284 and J234 (+1)
Net n1b2affab · joined across diagrams
- Function
- G284 Front Passenger's Front Airbag Crash Sensor — line to J234 Airbag Control Module 67endpoints onlyBasis: named after the two parts it connects
- Wire
ligr- Models
- B7 only
- Drawn in
- 2 diagrams, 2 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 join between diagrams2 guessed components
What is on this wire
Parts (2)
Inline connectors (1)
T17cpin417-Pin Connector, red, connector station A-pillar, right
Where these parts are
| Part | Location |
|---|---|
G284 | Wired into the main wiring harnessinferred from wiring |
J234 | Below centre console, in front of handbrake levermanual text p. 1125 |
T17c | On lower right A-pillar, behind trimmanual text p. 1099 |
Drawing
Wires are li (lilac) unless a colour is written on them. 4 parts and points, 4 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
- guess: the component label is not right at the symbol; the part was assigned by position.
54 · Airbags and Safety Belt Tensioners B7 · 1 stretch
Diagram 54 page · joined to other diagrams at J234/67
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.