Skip to content

Search is only available in production builds. Try building and previewing the site to test it out locally.

J343 · Control Module for High-intensity gas discharge lamp

Name
Control Module for High-intensity gas discharge lamp
Type
control module / relay
Models
B6 and B7
Diagrams
5

Location

Wired into the left headlamp wiring harnessinferred from wiring · 2 of 3 named splices on its wires

Other location statements (1)
  • Its wires run through T17a (Connector station - left A-pillar)inferred from wiring

Area: Front end

Articles

Pins

One row per pin and wire colour; the pin opens the page of its wire, traced across every sheet. "Connects to" lists the other pins on the same circuit within a diagram; splices and ground points it passes are under "via". The function says how it was worked out: stated by the manual, derived from terminal markings, fuses or the colour code. "Not stated" means the manual only shows what the wire connects.

Pins printed without a connector code likely Lighting & Power

PinWireFunctionConnects toModelsSheets
4
sw/bl 0.5 mm²
Fused supply from S18 (5 A, terminal 15) to J343 Control Module for High-intensity gas discharge lampderived
S18/18aB7 only469
14/31
br 0.35 mm²
Ground (terminal 31) at 26 (On front apron)stated
J343/5/31, L174/7/31
via 26, 179
B7 only469
5/31
br/ws 1.5 mm²
Ground (terminal 31) at 26 (On front apron)stated
L174/7/31, J343/14/31
via 26, 179
B7 only462 469
6/56b
ge/sw 1.0 mm²
Load-reduction positive (terminal 75x, off while cranking)stated
E1/2/XR, J519/23, J59/2
via A34
B7 only462 469

Diagrams

From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.