Wire between E272 and J285
Net nf977d1bc · joined across diagrams
- Function
- E272 Board Computer Function Selector Switch II — line to J285 Control module with indicator unit in instrument panel insert T32/12endpoints onlyBasis: named after the two parts it connects
- Wire
ge/bl- Models
- B6 only
- Drawn in
- 3 diagrams, 3 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
2 joins between diagrams
What is on this wire
Parts (2)
Where these parts are
| Part | Location |
|---|---|
E272 | In the centre console, bottomoutside reference |
J285 | Behind display unitmanual text p. 1125 |
Drawing
Wires are ge/bl (yellow/blue) unless a colour is written on them. 2 parts and points, 1 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
129 · Telematic without voice control (only for USA) B6 · 1 stretch
Diagram 129 page · joined to other diagrams at J285/T32/12
305 · Telematic without voice control (only for USA) B6 · 1 stretch
Diagram 305 page · joined to other diagrams at J285/T32/12
322 · Navigation system NS-LOW B6 · 1 stretch
Diagram 322 page · joined to other diagrams at J285/T32/12
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.