Wire between G253 and J446 (+2)
Net ndc100660 · one diagram
- Function
- G253 Right Front Center Parking Aid Sensor — line to J446 Control module for parking aid T12e/7endpoints onlyBasis: named after the two parts it connects
- Wire
bl/ws- Models
- B7 only
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 guessed component
What is on this wire
Parts (2)
Inline connectors (2)
Where these parts are
| Part | Location |
|---|---|
G253 | Front bumperinferred from name |
J446 | On rear cross panel, luggage compartment, left, behind trim near left rear lightmanual text p. 1126 |
T10i | On lower left A-pillar, behind trimmanual text p. 1100 p. 1101 |
T10x | Near front bumpersheet legend |
Drawing
Wires are bl/ws (blue/white) unless a colour is written on them. 4 parts and points, 3 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
- guess: the component label is not right at the symbol; the part was assigned by position.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.