Wire between G70 and J220
Net nd776823a-139.1 · one diagram
- Function
- G70 Mass Air Flow Sensor — line to J220 Motronic Engine Control Module 53endpoints onlyBasis: named after the two parts it connects
- Wire
bl/gn- Models
- B6 only · 4.2 S4
- Drawn in
- 1 diagram, 1 stretch
- Checked
- Not checked by hand. Extracted from the manual automatically.
What is on this wire
Parts (2)
Where these parts are
| Part | Location |
|---|---|
G70 | Wired into the engine compartment wiring harnessinferred from wiring |
J220 | In electronics box, plenum chambermanual text p. 1122 |
Drawing
Wires are bl/gn (blue/green) unless a colour is written on them. 2 parts and points, 1 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
12 · 4.2 l - Injection Engine (253 kW - Motronic - 8 Cylinder) engine code BHF B6 · 1 stretch
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.