Ignition-switched positive (terminal 15), fused by S243 (15 A, terminal 15)
Net nd06d5f98 · one diagram
- Function
- Ignition-switched positive (terminal 15), fused by S243 (15 A, terminal 15)statedBasis: splice D100 is named so in the legend
- Also named
- Ignition-switched positive (terminal 15)
- Wire
sw/lign/grsw/bl- Models
- B7 only · 2.0 TFSI
- Drawn in
- 1 diagram, 4 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
What is on this wire
Supply (2)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
Parts (1)
G70pin3Mass Air Flow (MAF) Sensor
Splices (1)
D100Plus Connection 2 (15) (in engine compartment wiring harness)
Inline connectors (1)
T17dpin1517-Pin Connector, red, connector station E-box, plenum chamber
Where these parts are
| Part | Location |
|---|---|
G70 | Wired into the engine compartment wiring harnessinferred from wiring |
J623 | Under the plenum chamber covermanual text p. 1204 |
S243 | Fuse panel at the left end of the instrument panel, fuse No. 43manual text p. 1116 p. 1120 |
D100 | Splice inside the engine compartment wiring harnesssheet legend |
T17d | In electronics box, plenum chambermanual text p. 1101 p. 1102 |
Drawing
Wires are sw/li (black/lilac) unless a colour is written on them. 5 parts and points, 4 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet. "→ track" is a reference box: the wire continues on that track, at the stretch its page link points to.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.