Skip to content

Search is only available in production builds. Try building and previewing the site to test it out locally.

Wire between G179 and J234

Net nc28d746d · one diagram

Function
G179 Crash sensor for side airbag, driver's side — line to J234 Airbag Control Module 73endpoints only
Basis: named after the two parts it connects
Wire
ge
Models
B6 only
Drawn in
1 diagram, 1 stretch
Checked
Not checked by hand. Extracted from the manual automatically.

What is on this wire

Parts (2)

  • G179pin 2Driver's Side Airbag Crash Sensor
  • J234pin 73Airbag Control Module

Where these parts are

PartLocation
G179Its wires run through T20 (Door A-pillar, left)inferred from wiring
J234Below centre console, in front of handbrake levermanual text p. 1125

Drawing

Wires are ge (yellow) unless a colour is written on them. 2 parts and points, 1 connections.

A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.

Stretch by stretch

Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.

307 · Airbag for driver, passenger with seat belt tensioner and side Airbag B6 · 1 stretch

Diagram 307 page

Page 919manual · Crash sensor for side airbag, Igniter for side airbag rear

TrackWireFromToNotes
57ge 0.35 mm²J234 73G179 2

From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.