Wire between F38 and J285 (+3)
Net nc1a2d574 · joined across diagrams
- Function
- F38 Ambient Temperature Switch — line to J285 Instrument Cluster Control Module T32/21endpoints onlyBasis: named after the two parts it connects
- Wire
ge/gr- Models
- B7 only
- Drawn in
- 2 diagrams, 2 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 join between diagrams
What is on this wire
Parts (2)
Inline connectors (4)
Where these parts are
| Part | Location |
|---|---|
F38 | Front end, behind the bumperinferred from name |
J285 | Behind display unitmanual text p. 1125 |
T2aj | In engine compartment frontsheet legend |
T10d | On lower left A-pillar, behind trimmanual text p. 1100 p. 1101 |
T14 | In engine compartment, leftsheet legend |
Drawing
Wires are ge/gr (yellow/grey) unless a colour is written on them. 7 parts and points, 7 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
62 · Standard Equipment B7 · 1 stretch
Diagram 62 page · joined to other diagrams at J285/T32/21
109 · Standard Equipment B7 · 1 stretch
Diagram 109 page · joined to other diagrams at J285/T32/21
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.