Battery positive, permanent (terminal 30)
Net na7bc2c55-517.6 · one diagram
- Function
- Battery positive, permanent (terminal 30)derivedBasis: terminal marking 30 printed at 1 pin on this net
- Wire
sw- Models
- B7 only · 2.0 TFSI
- Drawn in
- 1 diagram, 2 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 guessed component
What is on this wire
Supply (3)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
Where these parts are
| Part | Location |
|---|---|
A | In the plenum chamber at the rear of the engine compartment (battery box), under the plenum chamber coveroutside reference |
B | On the engine / transmission bell housinginferred from name |
C | On the engine, accessory driveinferred from name |
Drawing
Wires are sw (black) unless a colour is written on them. 3 parts and points, 2 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
- guess: the component label is not right at the symbol; the part was assigned by position.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.