Battery positive, permanent (terminal 30)
Net n24d47333 · one diagram
- Function
- Battery positive, permanent (terminal 30)statedBasis: splice D50 is named so in the legend
- Wire
ro- Models
- B6 only · 1.8T, 3.0 V6
- Drawn in
- 1 diagram, 2 stretches
- Checked
- Not checked by hand. Extracted from the manual automatically.
1 unresolved end
What is on this wire
Supply (1)
Fuses, the battery, alternator, ignition switch, and pins marked with a supply terminal (30, 15, 75, X, 50, 87).
S88pin?Fuse Strip (main fuse)
Splices (1)
D50Plus connection (30), in engine compartment wiring harness
Where these parts are
| Part | Location |
|---|---|
S88 | Main fuse carrier on the battery positive terminal, in the plenum chamber (under the plenum chamber cover)outside reference |
D50 | Splice inside the engine compartment wiring harnesssheet legend |
Drawing
Wires are ro (red) unless a colour is written on them. 3 parts and points, 2 connections.
A schematic of the connections, drawn by this site from the traced wire: not the layout of the sheets. Red-edged boxes are the supply side. Parts appear once with every pin this wire touches; splices, grounds and inline connectors once per diagram (their codes repeat between diagrams). A wire that continues through a reference box or an unnamed joint is one line. Not shown: what is inside the parts (fuse elements, relay contacts, switches). Dashed lines are uncertain links; dashed red boxes are ends the extraction could not resolve. Tap a line for its stretch below, its colour for the sheet.
Stretch by stretch
Every stretch of this wire as the sheets draw it: one block per diagram, one table per sheet. The track number opens the stretch on the drawn sheet.
From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.