Skip to content

Search is only available in production builds. Try building and previewing the site to test it out locally.

J502 · Tire Pressure Monitoring Control Module

Name
Tire Pressure Monitoring Control Module
Type
control module / relay
Models
B7 only
Diagrams
1

Location

Wired into the instrument panel wiring harnessinferred from wiring · 3 of 5 named splices on its wires

Other location statements (1)
  • Shown in the manual's location figures: Tire Pressure Monitoring System Overviewmanual figure p. 1316

Area: Instrument panel

Articles

Pins

One row per pin and wire colour; the pin opens the page of its wire, traced across every sheet. "Connects to" lists the other pins on the same circuit within a diagram; splices and ground points it passes are under "via". The function says how it was worked out: stated by the manual, derived from terminal markings, fuses or the colour code. "Not stated" means the manual only shows what the wire connects.

Pins printed without a connector code likely Antenna & CAN bus

PinWireFunctionConnects toModelsSheets
1
br 0.5 mm²
Ground (terminal 31) at 50 (In luggage compartment, left), 33 (Behind instrument panel, right)stated
via 50, 86, 238
B7 only505
2
ro/li 0.5 mm²
Battery positive, permanent (terminal 30a), fused by S17 (10 A, terminal 30)stated
S17/17a
via A1
B7 only505
11
bl/gn 0.5 mm²
not statedR96/1B7 only505
12
gr/bl 0.5 mm²
not statedR96/3B7 only505
15
or/gn 0.35 mm²
Comfort CAN Highstated
J285/17, J527/9
via A146
B7 only505
16
gn/bl 0.35 mm²
L-line (diagnosis), to diagnostic connection T16 pin 15stated
via A159
B7 only505
28
gr/gn 0.5 mm²
not statedR96/2B7 only505
31
or/br 0.35 mm²
Comfort CAN Lowstated
J285/18, J527/8
via A147
B7 only505

Diagrams

From the factory manual Audi A4 Wiring Diagrams and Component Locations, edition 12.2005, extracted automatically. Check anything important against the PDF sheet.