Remote key
Stub. The remote key's radio signal, its coding and key learning are not documented in this repo; only the receiver path is.
What this page will cover
Section titled “What this page will cover”The remote key’s radio link to the car: the receiver, how the signal is coded, how a key is learnt, and how J393 turns a button press into a lock or unlock command.
What the sources in this repo already say
Section titled “What the sources in this repo already say”- Radio remote control is standard on the B6 (Convenience system and anti-theft alarm).
- The remote-control aerial sits in the multi-communication bar; in the manual it is R47, “Central Locking and Anti-theft Alarm System Antenna”. It is an input to the central convenience control unit J393.
- The remote’s third button releases the boot lid (an input to J393, same article).
- The alarm arms only when the car is locked with the remote and disarms when it is unlocked with the remote (Convenience system and anti-theft alarm).
- Nothing in the repo says what frequency the remote uses, whether the code changes with each press, or how a key is learnt.
Open questions
Section titled “Open questions”- Is the receiver a separate unit behind R47, or inside J393? Which wire carries the signal from R47 to J393?
- What radio frequency and modulation does the remote use on the B6 and the B7, and is it the same?
- Is the code fixed, or does it change with each press (the roadmap lists this as unknown)?
- How is a remote key learnt to J393, and does this need the cluster or the immobiliser? Is it done through VCDS (address 46)?
- Does the key’s immobiliser transponder share anything with the remote, or are they independent?
- After a button press, which message does J393 put on the convenience CAN, if any?
- What is the range and behaviour with the car’s battery low?
How to capture or measure it
Section titled “How to capture or measure it”- Passive, on the car’s side: listen on the convenience CAN while pressing each remote button once, with a time note per press, doors closed, ignition off. Compare with the same buttons pressed out of range of the car.
- Read-only VCDS: look at address 46 identification and measuring blocks; write down anything about the number of keys.
- Do not replay or transmit captured signals at the car, and do not test on other people’s cars.
Related
Section titled “Related”Parts in the wiring data
| Code | Name | Models | Location |
|---|---|---|---|
R47 | Central Locking and Anti-theft Alarm System Antenna | B6 and B7 | Routed from the Comfort System Central Control Module -J393- |
J393 | Central control module for comfort system | B6 and B7 | At sill panel, front left |
Sources
- SSP 254 – Audi A4 '01 Technical Features — Audi AGPages 58–64: radio remote control, aerial in the multi-communication bar, J393.
- Audi A4 Wiring Diagrams and Component Locations (12.2005), via the wiring database — AudiR47 and J393 in the comfort-system diagrams.