Skip to content

Search is only available in production builds. Try building and previewing the site to test it out locally.

K-line and L-line

Stub. What the wiring manual says about the K-line and L-line (diagnostic connector T16 pins 7 and 15, splices A76 and A159), and what still has to be measured.

Applies to: B6 and B7StubOnly a starting point. Contributions welcome.

The physical layer of the two single-wire diagnosis lines: which connector pins and splices carry them, which modules sit on which line, and, once measured, the signal levels and timing. What the tester says over them is on the Diagnostics page.

  • SSP 254 says that “two diagnosis wires (K and L) are available” for communication between the modules and the tester. The A4 manual shows no separate diagnosis CAN at the socket. See Diagnosis access in CAN bus in the A4 B6/B7.
  • K-line: diagnostic connector T16 pin 7 (green/red), to splice A76 in the instrument panel harness, and on to cluster pin T32a/23. Per the same article, it connects the cluster/gateway and the engine, gearbox, ABS, airbag, comfort central, telephone, A/C and Servotronic modules.
  • L-line: T16 pin 15 (green/blue), to splice A159. It connects a second group: radio, navigation units, parking aid, memory seat, TPMS, J503, J810 and (B6) headlight range control.
  • The B7 also has an engine-harness K-line splice D166 for the engine and gearbox modules, and wires the drivetrain CAN to T16 pins 6 and 14. On the B6 those two pins are empty.
  • VCDS controller addresses says (from Ross-Tech) that the “second K-line” needs a dual-K interface on the B6.
  • What are the idle and active voltage levels on the K-line and on the L-line, measured at T16, with the ignition off, on and with the engine running?
  • Do the two lines differ electrically, or only in which modules are connected to each?
  • Are the K-line and L-line joined anywhere, for example in the cluster? The manual lists the cluster on A76 only; this has not been checked on a car.
  • What bit rate and framing does a module use on each line? The wiring manual and SSPs in this repo do not say.
  • Does the same module answer on the K-line in one generation and over CAN in the other (see the B7 notes in VCDS controller addresses)?
  • Is anything on these lines active when the diagnostic connector is not in use, such as wake-up pulses?
  • Measure only at the diagnostic connector pins named above, or at the splices A76 and A159, using the wiring data to find them. Start with a multimeter for resting voltage.
  • A logic analyser or oscilloscope on pin 7 or 15, listening only, while a tester such as VCDS runs an auto-scan. Record the car, interface, software version, ignition state and which module was being scanned.
  • Do not drive either line from your own hardware until you know what is connected to it: the line is shared by several control units.

Parts in the wiring data

CodeNameModelsLocation
J285Control module with indicator unit in instrument panel insertB6 and B7Behind display unit
A76Wire connection (K-diagnosis wire), in instrument panel wiring harnessB6 and B7Splice inside the instrument panel wiring harness
A159Connection (L) (in instrument panel wiring harness)B6 and B7Splice inside the instrument panel wiring harness

Sources