Drivetrain CAN messages
Stub. The message catalogue of the drivetrain CAN of the A4 B6/B7, which has no documented messages yet.
What this page will cover
Section titled “What this page will cover”The messages seen on the drivetrain CAN: identifier, length, sender and receivers, what each byte means, and how sure we are of it (the evidence levels). How messages are written down is on the CAN messages page.
No messages documented for this bus yet. How to contribute a capture
What the sources in this repo already say
Section titled “What the sources in this repo already say”- The bus runs at 500 kbit/s. High is orange/black, low is orange/brown, joined at splices A121 (high) and A122 (low) in the instrument panel harness, and D159 / D160 in the engine compartment harness. At the cluster it is on green T32a pins 13 (high) and 12 (low). See CAN bus in the A4 B6/B7.
- Engine, gearbox, ABS/ESP and airbag modules are on it, with the cluster and the steering column module J527. The article lists them under Which modules are on which bus.
- On the B7 the diagnostic connector brings this bus out on T16 pins 6 (high) and 14 (low). On the B6 those pins are empty. See K-line and L-line and Diagnostic connector (T16) pinout in the CAN bus article.
- The bus carries data about the running car such as road speed, engine speed and coolant temperature (same article).
- No message identifier or byte layout for this bus is in the sources of this repo.
Open questions
Section titled “Open questions”- Which identifiers are used for road speed, engine speed and coolant temperature on this bus, and which module sends them?
- Do the engine control modules of the B6 and the B7 (including the twin-module engines) use the same identifiers?
- Which of these signals does the cluster pass to the infotainment CAN, and how are they re-encoded?
- On the B7, which modules answer a tester on T16 pins 6 and 14?
- Does the bus go quiet when the ignition is off? SSP 269 says the drivetrain bus is switched by terminal 15; the A4 behaviour has not been captured.
How to capture or measure it
Section titled “How to capture or measure it”- Passive listening only. On the B7 the T16 pins 6 and 14 give access to the bus; on the B6 use the cluster’s green T32a pins 13 and 12, or any drivetrain module, as in the fault-finding steps of CAN bus in the A4 B6/B7.
- Set a CAN interface to listen-only at 500 kbit/s. Record the engine state, ignition state and gear, with times for each action.
- Keep leads short: SSP 269 warns against lengthening the drivetrain CAN by more than 5 m, even for testing.
- Transmit nothing on a live bus unless you know what each message does.
Related
Section titled “Related”Parts in the wiring data
| Code | Name | Models | Location |
|---|---|---|---|
J285 | Control module with indicator unit in instrument panel insert | B6 and B7 | Behind display unit |
Sources
- SSP 254 – Audi A4 '01 Technical Features — Audi AGWhich modules are on the bus, and what the cluster gateway does with it.